Skip to main content
 

Contact Switch AT Lite

The Contact Switch AT Lite is the perfect dropper solution for smaller shredders weighing less than 62kg / 136lbs. Operating at a lower pressure, the Contact Switch AT Lite requires less weight to lower the saddle and makes lever engagement easier. Adjustable travel caters to a variety of rider heights and an innovative rotating cable actuator makes installation on smaller frames a breeze.

Easy Drop

Responds with less than 62kg/136lbs of effort.

Purpose-built to operate at lower pressure, the innovative cartridge system on the Contact Switch AT Lite responds quickly and with easy lever engagement, making it the perfect dropper for riders under 62kg / 136lbs.

Maximum travel, Minimum Length

Up to 30mm of travel reduction

With 30mm of tool-free adjustable travel and a shortened chassis for each post length, the Contact Switch AT Lite Seatpost fits a wide range of rider heights, frame sizes and suspension designs. Easily reduce travel with 5mm, 10mm or 15mm spacers at the seatpost collar and store unused spacers at the bottom of the post.

Get Low

Innovative 180-degree rotating actuator for easy routing

Maximum insertion for a dropper post is critical, but the curved or interrupted seat tubes found on full-suspension frames can make cable routing difficult when the post is all the way in. The Contact Switch AT Lite dropper features a unique 180-degree rotating actuator that allows for easier cable routing on a variety of seat tube designs, maximizing seatpost insertion and improving cable action.

ADJUSTING TRAVEL

reducing travel on seatpost instructions
  1. Remove the post from seat tube to access travel spacers at the base.
  2. Remove travel spacers.
  3. Insert the post back in seat tube without tightening seatpost collar bolts..
  4. Press the remote lever to drop the post at least 40mm.
  5. Unscrew collar ring assembly.
  6. Gently remove desired number of travel spacers along the tear lines, and install under the bushing. Make sure the spacers sit securely inside the bushing groove.
  7. Screw collar ring assembly firmly back on the seatpost, adjust seatpost to desired height and tighten seat post collar bolts to correct torque.
  8. Pop saddle back to new maximum height and check rider fit.

ADJUSTING THE ROTATING CABLE ACTUATOR

rotate actuator in seatpost graphic
  1. Push down actuator lever with a flathead screwdriver, to drop the post at least 40mm.
  2. Gently remove the retaining ring with a 3mm flathead screwdriver.
  3. Gently separate the upper section of the post and the actuator with a rubber mallet.
  4. Rotate the actuator 180 degrees to face the opposite direction.
  5. Install the actuator back into the upper section of the seatpost.
  6. Re-insert the retaining ring.
  7. Push the remote lever to pop seatpost back up to maximum height.

Shop the Gear

Contact Switch AT Lite
Contact Switch AT Lite